Measure 1 teaspoon of household bleach per gallon (of the tank capacity). Pour it inside the tank and immediately add fresh water to the tank until it’s full. Turn on the water pump and let the bleach water run through all taps for two minutes.
Use an anti-bacterial spray or liquid bleach for disinfecting the tank and pipes. This is necessary to ensure that they are decontaminated and free of germs. Fill the tank with water once more and run the liquid mixture through the taps to sterilise the pipes.
A great way to get rid of that mineral build up is to flush your hot water tank, but if that isn’t enough you can add vinegar to your hot water tank, which will help to break up the deposits so they’ll drain more easily. The same cleaning techniques can also be applied to patio heaters.
Use 1/4-cup of liquid household bleach (sodium hypochlorite) for every 15 gallons of fresh- water tank capacity. 4. Pour the solution directly into the fresh water tank.
Simply mix hot water with laundry detergent powder or liquid to make a cleaning solution. Scrub the inside of the tank. Use a bristle brush or abrasive sponge to scrub the inside of the tank, with or without your cleaning solution.
Without draining out the water, pour white vinegar into the tank, stopping at least an inch below the top rim. Let the vinegar-water solution sit for 12 hours to dissolve mineral deposits, rust, and mildew. Flush the toilet a couple of times to remove the vinegar from the tank.
If the clog is severe, pour up to one-half a cup of baking soda in the toilet. Remember to use equal parts of vinegar and baking soda. So, for every one cup of baking soda you use, use one cup of vinegar. After you’ve poured the baking soda and vinegar in the toilet, pour a pot or kettle of hot water down the toilet.
Fill your fresh water tank with at least 15 gallons of a 50/50 solution of water and white vinegar. Open your kitchen faucet and run your water pump until water comes out and you smell vinegar. Turn the water off and turn on the water heater. It will take at least 20 minutes for the water to reach at least 130 degrees.
Vinegar is a great toilet cleaning solution. Not only is it free of chemicals and naturally antibacterial, it’s also an acid, so it will remove minor lime and calcium deposits. All you need to do is pour a couple cups of vinegar in your tank and let it sit for an hour or so, then scrub and flush to rinse.
Vinegar will not harm your toilet’s tank, bowl or inner components. The substance is safe to use and removes dirt, grime and mineral stains, and it deodorizes toilets without the need for purchasing and using a commercial toilet cleaner. Turn on the water and flush the toilet several times.
Benefits: Vinegar is a natural and effective way to disinfect and destroy rust and hard mineral deposits, while baking soda helps your toilet tank water maintain a proper pH to keep your water soft and resistant to mould and mildew.
White vinegar and baking soda in equal parts is a cost-efficient and effective means of getting rid odors in a toilet. Add them to the tank, mix them in and then use the toilet brush to gently scrub the tank. Let it sit for three hours, scrub the tank again and flush.
Try the vinegar one more time. If it still doesn’t work, then consider a hydrogen peroxide-based bleach or a non-toxic toilet bowl cleaner product (this is the one that I use when I don’t use vinegar). The acidity in vinegar kills germs, bacteria and mold on contact.
Clean the stains with a toilet brush, and rinse with warm water. Repeat if needed. Cleaning a toilet tank with vinegar and baking soda is a safe and effective method.
Do you like this article?