How thick can you apply ardex?

Thickness of Application

ARDEX FEATHER FINISH can be installed from a true featheredge up to 1/2 in. (12.7 mm) over large areas.

Can you sand ARDEX FEATHER FINISH?

The final coat when dry should be sanded as smooth as possible before putting on color or sealant. I would allow 1 day between coats. Ardex Feather Finish dries really fast, but better to give it 24 hours to be sure. … The final coat when dry should be sanded as smooth as possible before putting on color or sealant.

How many square feet does a bag of ARDEX FEATHER FINISH cover?

Coverage: 16.7 sq. ft. per bag at 1/4”, 33.3 sq. ft.
…
Technical & Specification Documents.
Brand Ardex
SKU 226757

Is feather finish waterproof?

ARDEX FEATHER FINISH – Laminate Floors and Waterproof Flooring-Carpet-Wood-Tile-Parquet-Soundproofing-Vinyl-Porcelain in Miami Florida Talula Floors.

Is Henry feather finish the same as ardex?

The Henry Feather Finish is the same stuff as is in this Ardex bag. They are made by the exact same company -just different packaging. I found the Henry at Home Depot. You just have to search because different territories in the US carry different products and brands.

How do you seal ARDEX FEATHER FINISH?

Can you use ARDEX FEATHER FINISH outside?

ARDEX K 301™ Exterior Self-Leveling Concrete Topping is a self-leveling topping and underlayment for fast-track resurfacing and smoothing for exterior and interior applications over concrete and approved, properly prepared, non-porous surfaces, including terrazzo, epoxy coatings and ceramic and quarry tile – on, above …

What is the PSI of ARDEX FEATHER FINISH?

4200 psi
Using advanced Portland cement chemistry with a self-drying matrix, ARDEX SD-P is ideal for patching and reaches a compressive strength of 4200 psi. It was developed to reduce curing time on pressed-for-time jobs.

What is feather finish used for?

ARDEX FEATHER FINISH® is an underlayment formulated from a blend of Portland cement and other hydraulic cements that provides a smooth, permanent finish for a variety of substrates prior to the installation of today’s demanding floor coverings, including sheet vinyl and VCT (vinyl composition tile).

How do I apply for ardex Township?

For smaller quantities, use 2 parts of powder to 1 part water by volume. Use a margin trowel and mix vigorously for 2 to 3 minutes. Mix thoroughly to obtain a lump-free consistency. The pot life of ARDEX TWP is approximately 15 to 20 minutes at 70°F (21°C).

Does Ardex grout need to be sealed?

While not required, a penetrating grout sealer can be applied. Follow sealer manufacturer’s recommendations for substrate preparation, application and cure. Please note that ARDEX FL must set a minimum of 72 hours (70°F / 21°C) prior to being submerged in water.

What is ardex waterproofing?

ARDEX S 1-K™ One-Component Waterproofing and break Isolation Membrane is an easy-to-use, single-component, load-bearing waterproofing compound that produces a flexible, positive-side waterproof coating for all common interior building substrates requiring protection from topside water exposure that could damage tile …