How do I reset my GE front load washer?

How to reset the washing machine:
  1. Press POWER to turn the washer off.
  2. Unplug the washer from the power outlet or turn the circuit breaker to the unit off.
  3. With the power disabled, press and hold the START/PAUSE button for 5 seconds.
  4. Plug the washer back in, or turn the circuit breaker back on.

Is there a reset button on a washing machine?

Most newer washing machines come with a reset feature that allows you to restart the washer after it experiences an error code or fault. Some machines have a button you push to reset its motor. On a machine without a reset button, unplugging the washer and then plugging it back in often serves as the means to reset it.

Why won’t my GE washer drain and spin?

This usually indicates the washer took too long to pump the water out. There may be a clog. Press Start to resume the cycle or you can select Drain & Spin and press Start. If the washer drains properly, then the clog has likely cleared.

Why won’t my GE washer fill all the way?

If your washer won’t fill, check the hot and cold faucets to make sure they’re both turned on fully. Check the fill hoses, which connect to the upper back left of most GE washers, and make sure the line has no kinks. If the problem persists, turn off the water and remove the fill hoses.

How do I reset my deep fill GE washer?

How do I reset the lid lock on my GE washer?

Top Load Washer – Lid Lock Feature
  1. Make sure the washer is paused (press Start/Pause). During spin, this can take up to 3 minutes for the basket to stop spinning and allow you to open the lid.
  2. Unplug the washer for a minute to reset.

Why does my GE washer keep pausing?

The door latch can cause a GE frontload washer to pause during a cycle. If the door physically opens, the washer will pause. However, if the door stays locked but the switch is bad then the control will think the door is open and the washer will pause. If the door will not latch then the washer will not start.

Why is my GE washer not starting?

Causes. When a GE washer stops working, it could be because of a broken spin belt, a blown fuse, a melted wire, a backed-up water pipe, or a burnt-out power outlet. The most straightforward reason your GE washer isn’t working anymore is that it’s not plugged into a reliable power source.

Why has my washing machine stopped working?

Washing Machine Has Fill Problems

Another reason for the washer not filling may be that the water-level switch, timer, or temperature selector is broken. If your washer is overfilling, you may have a defective water-inlet valve or water-level switch.

Do GE washing machines have a fuse?

GE washer fuse or circuit Breaker washer, is located behind the control panel.!

Where is the line fuse on a GE washer?

Where is the fuse in my washing machine?

Lid Switch or Fuse

Your machine may have a special fuse located inside the control panel. Unplug the washer, then remove the couple screws on the dashboard to access the panel. A blown fuse will be black in color and must be replaced.

How do I fix the Start button on my GE washer?

How do I change the control panel on my GE washer?

How do you remove the button on a washing machine?