What does it mean when your radio says protecting send service?

Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.

How do you reset a JVC car radio?

Almost all JVC head units have a reset button that is located at the side of the volume control knob or under the faceplate. For those who do not, you need to press and hold down both ON and SELECT buttons for 5-8 seconds to restore factory settings.

How do I get my radio out of Protect Mode?

Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn’t go away on its own, press the reset button. If that doesn’t work, disconnect the power lead from your receiver for 30 seconds and then reconnect it. If it still doesn’t work, it’s time to take it to the dealer.

What does Warning DC offset error mean?

If the power is not turned ON (“Miswiring DC Offset Error”, “Warning DC Offset Error” is displayed), the speaker wire may have a short- circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked.

How do I get my JVC radio out of Protect Mode?

The best way to fix any protect mode issue on your JVC car stereo is by disconnecting everything from the device and performing a factory reset. With this, you should be able to completely get rid of the problem with most cases being solved without having to replace or repair anything.

How do I turn on auto mode on my JVC receiver?

Please ensure you are connected to JVC Music play in Auto mode by pressing the “USB Mode” button on the receiver to toggle between these 2 modes.

How do I pair my JVC radio?