How do you reset the airbag light on a Nissan Altima?

How to Reset The Airbag Status Light On A Nissan
  1. Insert the key into the ignition and turn the key to ON.
  2. Notice that the light will stay on and then start blinking. …
  3. Wait 5 seconds. …
  4. Wait 5 seconds and repeat step 1. …
  5. When you are complete, you should have inserted the key and removed it for a total of 6 times.

How do I reset my airbag light button?

Turn Your Ignition on and Off.

First, turn the ignition switch on. Next, wait for the airbag light to turn on – it normally stays lit for seven seconds before shutting itself off. Then, immediately turn off the ignition switch, and wait three seconds. Repeat the initial steps once or twice before starting the engine.

How do I reset my solid airbag light?

How to Reset an Airbag Light
  1. Put the key into the ignition and turn the switch to the “on” position.
  2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
  3. Repeat Steps 1 and 2 two more times.

Will disconnecting the battery reset the airbag light?

No, this information is stored in non volatile memory. The airbag light is usually on if there’s a problem with the system. Even if you could clear the code which is reporting that, if the problem isn’t fixed then it will just be detected again, and the light will come back on.

How do you reset the airbag light on a 2009 Nissan Altima?

How do you reset the airbag module on a Nissan?

Can you reset airbag light without tool?

In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.

Can a blown fuse cause the airbag light to come on?

Blown fuses can definitely cause the airbag light to come on. … When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.

How do you trick an airbag light?

What scanner will reset airbag light?

Autel AutoLink AL619 OBD2 Scanner, ABS, SRS Airbag Scan Tool, Turn Off ABS, Airbag Warning Lights, Ready Test, Advanced Version of ML619.

Where is the airbag sensor?

Usually, you have two airbag sensors located in the front of your vehicle behind the bumper. There is often also one airbag sensor installed inside of each door of your car.

What does it mean when the airbag light stays on?

5. Your Airbags May Not Deploy In The Event Of A Crash. The airbag light is an indicator that there is a problem with the vehicle’s Supplemental Restraint System. … When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision.

How do I get an airbag code?

How do I check my airbag light code?

The airbag codes are double digit numbers. To read the codes, count the number of times the light flashes, wait for the pause and count the flashes again. For example, two flashes, a pause and four flashes mean that your airbag system’s problem is a code 24.

How much does it cost to turn off the airbag light?

Number 1 — Reset Airbag Light

This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.