【How-to】What are the 2 settings on a stapler

What’s the other staple setting for?

The other setting, the one that splays the staple points outward, is for temporarily attaching papers that are intended to be separated again. The attachment is looser, and it’s easier to remove the staple without chewing up the corners of the pages.

How do you adjust a stapler?

What do staple numbers mean?

Most staples have two reference numbers that are normally standard throughout the brands. … The first digits, i.e. 24/## or 26/## indicate the gauge of the wire, the thickness. The second number reflects the length of the staple leg, or shank, and is measured in millimetres.

How do you adjust a manual staple gun?

How do you use a 3 in 1 staple gun?

How do you adjust staples depth?

7) To adjust the driven-in depth of a staple, loosen the screw that secures a push lever piece. If the staple is driven in deeply, adjust the push lever piece to ”down”, and if it’s driven in shallowly, adjust the push lever piece to “up”. Tighten the screw to fasten the push lever piece.

Why is my staple gun not firing?

When any important part is broken or worn out, the tool simply won’t work. … Make sure you are using staples of the correct size and type for the tool. Small variances can gum up the works and cause staples to jam or defeat the spring or hammer mechanisms.

How many staples are in a staple gun Strip?

210 staples

Staple strips are commonly available as “full strips” with 210 staples per strip.

What is the screw on top of a staple gun for?

The pressure screw (C) may be adjusted so that it will apply the appropriate force to the staple, or nail, depending upon the material being stapled. Note: The softer the material, the less force will be required to drive in the staple or nail. Excessive force may damage the material being stapled.

Why is my stapler not stapling?

If unable to shake the jammed staple out, try to staple a single sheet of paper while the unit is jammed. This could possibly force the jam outward, clearing the unit. If this does not work, try using any sizable tool or nearby accessory, try to fish out the jammed staple through the “front teeth” of the stapler.

How do you load a staple gun?

Why are my staples bending?

These are there because that base plate is reversible; you can rotate it to change which groove the staple wire hits when it comes through the stack of paper you are fastening together. … The setting most people use is the one that causes the legs of the staple to bend inward to hold a stack of papers firmly together.

Where does the big spring go in a stapler?

How do you take staples out of a stapler?

How do you fix a broken stapler that won’t staple?

Use a sharp object to push the jammed staple up from the bottom. Any of the following should work: tweezers, scissors, a flathead screwdriver, or needle-nosed pliers. Push the prongs of the jammed staple upward to try and loosen it from the grip of the stapler.